Vinyl basement windows

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about Vinyl basement windows

Most often in the basement, organize the warehouse, or use it for storage. If your garden plot you collect a good harvest, you won’t have the headache of where to store the gifts of nature and seaming. At a depth of 1.5 – 2 m keeps stable temperature about 5 degrees in winter and 10 degrees in summer. And this is the perfect conditions for food storage. Browse some photo of Vinyl basement windows

The height of the basement: technical premises take from 1.9 to 2.2 m. If you are going to do from the basement of a dwelling, the height may be equal to the height of the floor or just below (2,5-2,7 m). At the close inception of the groundwater to the ground surface basement need to build from solid reinforced concrete (floor, walls). It is better to take concrete below grade M500 (or make concrete using cement grade M500).

The order of construction of the basement depends on the level of groundwater. If they are too close to the surface, first formed the floor. Otherwise, work can begin with the construction of walls. First excavated pit with some margin in width (for the device of the formwork). Formed a cushion of sand and gravel. You then install the formwork, laying a waterproofing material, laid rebar and poured concrete.

To build a basement under the garage for a start you need to develop the project. Ideally, plan to work on creating the basement you need before you begin the construction and equipping of the garage. This will allow you to choose the most suitable way of laying the Foundation, consider high-quality ventilation top and bottom areas and also deliver reliable waterproofing.

Because excavation for construction of the Foundation is a very time consuming job, mostly used excavator. Before excavation it is desirable to remove the useful layer of soil. Ditch digging 30 cm more than the approved size of the Foundation. Part of the ground will be useful for back filling, so no need to take out all the soil excavated from the pit from the site. The bottom of the pit and rams.

The main enemy of the Foundation of any home is the groundwater and meltwater. Moisture destroys the rebar of reinforced concrete structure, when the load on them in thousands of tonnes may result in premature failure of the elements of which they consist. Waterproofing the outside and penetrating waterproofing basement from the inside is not a whim but an urgent need, which will ensure the safety of the entire structure.

The most reliable will be a monolithic wall. They still at the stage of creating the armature plate make the vertical reinforcement bars: outer – length 1.5-1.7 m, inner 1.2-1.3 m. When the base plate attains 70% of its strength, continue to knit the reinforcing frame in accordance with the project. Reinforced inner and the outer walls serve as ribs for slab Foundation. Height of basement walls may be different, depending on the destination premises.

Reinforcement of monolithic basement walls is performed using the power set, which is selected based on the thickness of the walls and anticipated load. For monolithic walls, often use a box scheme. In this case, the armature is collected by means of two power series and connecting horizontal rows of thin reinforcement products. Reinforcement of retaining walls perform better under the supervision of experts. For this work used special fittings with thickness up to 50 mm.

Water from the drainage system can be abstracted in a septic tank, a drainage ditch or specially for this purpose built cumulative well. In the simplest version it is a deep pit, filled with broken brick, gravel, crushed stone, fine construction debris. It is important that the bottom of the pit was permeable, so when it is digging, it is desirable to achieve a layer of soil, which would be a sufficient amount of sand or sandy loam.

If the basement has a small volume, it is possible to use a slightly simplified scheme. The main difference between supply and exhaust air duct is that it delivers and removes air with a single design, which has both exhaust and supply channel. However, in this case will be confined to only a small volume of air.

When building a house on wet soil, depending on the values of the estimated load insulation of a floor heated room in the basement or cellar should be carried out according to the scheme adopted for load-bearing floors on the first floors of buildings. Created when groundwater pressure and, depending on the loads that create columns and walls, the insulation material of extruded polystyrene foam can be placed under concrete slabs laid on gravel, and over them.

Before you start heating the communication to the ground floor, it is recommended to assess its condition and determine whether the need and feasibility of heating. If you meet all the construction technology of the ground floor, good insulation and waterproofing, it remains only to choose the right equipment for the heating of the ground floor, its installation and laying of wiring. Read related articles on the subject of Vinyl basement windows

Basement to build more complicated if you are not an expert in this matter. Before the construction of the basement of the foam it is also important to choose its location. Proper organization of the construction process will allow you to get a good result, that is, to preserve the original taste of pickles from the cellar or the functionality of the tools stored in the basement out of foam blocks, and to create out of the basement the whole separate rooms.

Leave a Reply