The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about Size of basement windows
Finally, a basement with small Windows and modern finishes, it is possible to turn into a bright and living room. As we can see, the functions in the basement and why you need it can be a great many, the main thing that it was safe to be. Browse some photo of Size of basement windows
Before you begin construction, you should accurately determine the size of the basement. They can be very different and depend on the design solutions of the future home and the preferences of the owner. When excavation experts do not recommend to deepen a basement in the ground to full height.
The order of construction of the basement depends on the level of groundwater. If they are too close to the surface, first formed the floor. Otherwise, work can begin with the construction of walls. First excavated pit with some margin in width (for the device of the formwork). Formed a cushion of sand and gravel. You then install the formwork, laying a waterproofing material, laid rebar and poured concrete.
The Foundation should be doing the most robust and reliable that its walls could successfully resist the horizontal shifts due to the pressure of the surrounding soil. As a Foundation base is recommended to use a pillow of in-situ concrete, associated with ribbon cage. As the weight of the slab is large enough, the sole should be broad.
Development of the Foundation pit. For this we need a backhoe and dump truck for the removal of excess soil. There are few secrets. But the soil it is necessary to take not completely but only 2/3. The remaining third is still useful to us. Digging a Foundation for a house with a basement is done based on the design size of the house, adding roughly one and a half meters at the edges, so that later you can safely seal the resulting structure.
Waterproofing cellars and basements are necessary to protect the floors and walls of buildings against the penetration of groundwater and surface water. Basement waterproofing can be performed from the outside of the building and from the inside. The effects of water, waterproofing is divided into three types: gravity, protionamida , protivokariesnoe.
Since the main enemy of a basement is groundwater, the wall material should be strong and the most waterproof. Sometimes you can find recommendations to build the basement walls of the Foundation blocks. Although this solution is cheaper than the monolithic walls, but it is only suitable for sites with low groundwater level. Special attention in this case should be given to waterproofing the walls.
There are different patterns of reinforcement of the basement. For walls made monolithic method, most often used box diagram. The Assembly of the valves is performed by the device of two power series and connecting them with horizontal, thin reinforcing elements. For a basement wall reinforcement mesh is chosen sufficiently elastic, and the binding of elements it is better to use wire without welding.
Drainage of the basement will save your home from seasonal flooding and strengthen the Foundation walls of your home. After all, through careful drainage of the supporting ground and backfill can reduce groundwater levels and reduce soil moisture. Ultimately, with drainage, you can increase the carrying capacity of the supporting soil, and affect the ability of soil to deformation of swelling, destroy the structure of the Foundation.
To implement natural ventilation will require developing devices, supply and exhaust ducts. The hole of the exhaust duct will need to be placed under the ceiling, and the inlet – near the opposite wall, about half a meter from the floor. With this placement can provide optimal circulation of air masses.
When building a house on wet soil, depending on the values of the estimated load insulation of a floor heated room in the basement or cellar should be carried out according to the scheme adopted for load-bearing floors on the first floors of buildings. Created when groundwater pressure and, depending on the loads that create columns and walls, the insulation material of extruded polystyrene foam can be placed under concrete slabs laid on gravel, and over them.
Pretty easy to do just water heating all over the house and in the basement. Why choose this type of heating. Arrange heating of this kind is possible using the gas boiler and electric. Here, of course, can not do without drawbacks. Since the space is heated by steam, the highest temperature will remain at the top of the room. And of course there are benefits: the system will always have hot water. Read related articles on the subject of Size of basement windows
It is worth noting that to do basements in existing buildings is not recommended because it will cause high construction costs. In addition, increase the risk of damage to the Foundation of the building, especially if the device runs basements with their hands.