Replacement basement windows sizes

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about Replacement basement windows sizes

In the basements of homes suit different premises: garages, pantries, baths (including a pool), workshop, Laundry and storage area. The basement is used as a vegetable store, the storage of the tubers and bulbs of flowers. Many people throw in the mushrooms, trying to breed exotic birds and animals. The basement seems to be a place for such studies, which are impossible to do in the premises. Browse some photo of Replacement basement windows sizes

Not enough for the good basement just to dig a hole. After all, this room should be reliable, resistant to moisture and is well ventilated. Before the construction of the basement, you must first dig a hole 2 meters deep and see if there is typed in water. If the water doesn’t come, you’re in luck. Otherwise, there is a need to carry out waterproofing works. And it should be done carefully, since the error is then very difficult and expensive to eliminate.

Floors and basement walls must resist the pressure of the soil, to protect the basement from water and, to some extent, to insulate the room. To ensure durability, exterior basement walls should support internal of not more than 3 to 4 m To ensure protection against water, walls and floor of the basement pitch in the form of complex multilayer structures. In the best case, when ground water table is below the floor level of the basement, enough for 2 layers

When building the Foundation for a country house it is worth considering the many climatic and geological conditions: the proximity of groundwater to the ground surface level, the tendency of the soil to deformation, and frost heave to. If the water table near the ground surface and is above freezing, there is a considerable risk of basement flooding, subsidence and destruction of the entire building. To avoid this, you need to spend on the site drainage works and to choose the right Foundation design for your home.

Development of the Foundation pit. For this we need a backhoe and dump truck for the removal of excess soil. There are few secrets. But the soil it is necessary to take not completely but only 2/3. The remaining third is still useful to us. Digging a Foundation for a house with a basement is done based on the design size of the house, adding roughly one and a half meters at the edges, so that later you can safely seal the resulting structure.

Basement waterproofing should be carried out in several stages. In the beginning it is necessary to conduct surveys of the basement. If the basement already has water then it is necessary to completely drain it, then check the condition of the subfloor (slab) for strength, check the junction floor-wall, condition of basement walls. To develop recommendations on waterproofing a basement.

After the spacecraft made a plan and made calculations of the basement walls, you can start immediate construction. To basement walls were reliable, it is necessary to use the technology of casting monolithic strip Foundation on a sand cushion. The thickness of walls constructed in a basement may vary from 200 to 400 mm, depending on soil and number of storeys of the structure.

Reinforcement of walls enables the whole building or its individual structures to withstand various loads: pressure, torsion and bending. Also, this procedure increases the service life of products and enhances their performance. Rebar is made from special grades of steel. It must have high wear resistance and resistance to various deformations. Feature of any valve is that it cannot be welded, can only be linked.

Drainage of the basement will save your home from seasonal flooding and strengthen the Foundation walls of your home. After all, through careful drainage of the supporting ground and backfill can reduce groundwater levels and reduce soil moisture. Ultimately, with drainage, you can increase the carrying capacity of the supporting soil, and affect the ability of soil to deformation of swelling, destroy the structure of the Foundation.

In fact, ventilation is a system of pipes or shafts to ensure the normal parameters of humidity, temperature and ventilation in the house. The ventilation of the basement of a private house may be compulsory and consist of a network of ventilation ducts with the supply device and an exhaust fan, and can be natural and consist of a supply and exhaust pipe.

In the underground part of the house has a fifth of the total teplopoteri. The lack of thermal insulation of the basement will lead to significant heat loss throughout the house. The insulation will protect the walls of the basement from freezing, prevent the appearance of dampness and mould development. Theoretically, you can insulate the basement the outside and inside, but more efficient continuous exterior insulation on the perimeter. Internal insulation is recommended, use only if you the outer.

The procedure for heating floor has its own quirks and nuances. Before the arrangement of heating it is recommended to take the necessary measures, which will not allow the heat to go out through the wall. This is done the insulation and waterproofing of exterior of the walls. To accomplish these goals, we need to dig out the Foundation. Read related articles on the subject of Replacement basement windows sizes

It is worth noting that to do basements in existing buildings is not recommended because it will cause high construction costs. In addition, increase the risk of damage to the Foundation of the building, especially if the device runs basements with their hands.

Leave a Reply