How to replace basement windows in cinder block foundation

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about How to replace basement windows in cinder block foundation

Finally, a basement with small Windows and modern finishes, it is possible to turn into a bright and living room. As we can see, the functions in the basement and why you need it can be a great many, the main thing that it was safe to be. Browse some photo of How to replace basement windows in cinder block foundation

It is advisable to build a basement or cellar in a house located on high dry soils. This decision is justified structurally and economically in a strip Foundation and ground slab, as the additional expenditure associated with the construction will be 3-5 times less than if you build a separate room with a similar usable area.

Projects single-storey houses with a basement can be called the most common. The basement here is typically used to accommodate boilers, communication systems, etc. During the construction of the basement, special attention should be paid to the location of groundwater and the level of freezing of the soil, as these indicators influence the depth of the base under the house and the depth of the basement. If you do not consider these parameters when raising the groundwater in the basement moisture appears, which is going to be quite difficult.

If you decide to make a basement below ground, you should consider the depth of the groundwater and the soil type. If these characteristics allow you to drill into the ground, the Foundation to a house with a basement can be made in two versions: a monolithic concrete slab or strip Foundation. In the first case, it can be directly on the plot to fill the desired area with concrete or to use a ready-made factory plate. If selected, the construction of strip Foundation, it can also be done in different ways: modular and monolithic.

To make a future home large basement, you must excavate, and using formwork to build in this strip Foundation, so that it was located under each of the walls. In addition to filling concrete into the formwork, this method of construction it is possible to use ready-made concrete blocks. But then definitely need a crane.

Usually basements gidroizolyatsiya already in the construction phase of the building. Wherein the protective material is laid under the floor, and they handled the walls of the underground space on the outside. However, nothing lasts forever, and sooner or later the waterproofing layer loses its quality. In the basement there is dampness. Of course, you can dig it up from the outside and glue the walls with another layer of waterproofing. However, the procedure is pretty slip. Besides the floors so the outside will not saibaiwei. In this case, is usually used some other way of protection from dampness, waterproofing basements from the inside.

Based on the building regulations the walls of the basement suit of reinforced concrete class B12,5 about compressive strength, precast concrete blocks or masonry (brick) masonry. Precast concrete blocks should also be made of the concrete class B12,5 and meet the requirements of the Standards. Structurally, the basement walls is usually combined with strip Foundation, and ceiling – reinforced concrete ground slab.

Reinforcement of basement walls is quite a complex construction process. In this case the whole building or its individual structures is given increased strength from the pressure, torsion and bending moment. In this case, increases the life of the structure and increase its performance.

Note that the carrying out of drainage works to drain the basement of the house will significantly reduce the area of the basement. First of all you need to pay attention to its height: it will inevitably decrease by 20-30 cm, as the drainage from the basement without laying drainage pipes and floor elevation will not work. The only way to preserve the aesthetic appeal of a well-ordered space.

In fact, ventilation is a system of pipes or shafts to ensure the normal parameters of humidity, temperature and ventilation in the house. The ventilation of the basement of a private house may be compulsory and consist of a network of ventilation ducts with the supply device and an exhaust fan, and can be natural and consist of a supply and exhaust pipe.

In the underground part of the house has a fifth of the total teplopoteri. The lack of thermal insulation of the basement will lead to significant heat loss throughout the house. The insulation will protect the walls of the basement from freezing, prevent the appearance of dampness and mould development. Theoretically, you can insulate the basement the outside and inside, but more efficient continuous exterior insulation on the perimeter. Internal insulation is recommended, use only if you the outer.

If the basement will be used as a room, for example, gym, playroom or office, this room is supported by a complete system of heating – is an offshoot of the General heating system of the house. Then the heating of the basement of a private home is one of the types of fuel: solid, gaseous or liquid. Also in this room is possible to install an independent boiler or electric heating. Read related articles on the subject of How to replace basement windows in cinder block foundation

If you decide to build it all yourself, then be sure to get support. Even the trite advice of neighbors who have already made the cellars in their houses and know all about the level of groundwater and the terrain. When possible, the construction of the basement must be done, by hiring professionals.

Leave a Reply