How to install replacement basement windows

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about How to install replacement basement windows

Finally, a basement with small Windows and modern finishes, it is possible to turn into a bright and living room. As we can see, the functions in the basement and why you need it can be a great many, the main thing that it was safe to be. Browse some photo of How to install replacement basement windows

The construction of the basement is the first stage of construction of a private house, unless, of course, not to consider the Foundation and planning of the territory. In some situations, the construction of the Foundation is just the beginning of the construction of the basement – such is the approach chosen in the construction of low and light buildings. The whole process of construction of basements can be divided into three main stages: this is the digging (excavation device), concrete Foundation pouring and the construction of basement walls, which in turn are part of the Foundation.

Floors and basement walls must resist the pressure of the soil, to protect the basement from water and, to some extent, to insulate the room. To ensure durability, exterior basement walls should support internal of not more than 3 to 4 m To ensure protection against water, walls and floor of the basement pitch in the form of complex multilayer structures. In the best case, when ground water table is below the floor level of the basement, enough for 2 layers

The Foundation should be doing the most robust and reliable that its walls could successfully resist the horizontal shifts due to the pressure of the surrounding soil. As a Foundation base is recommended to use a pillow of in-situ concrete, associated with ribbon cage. As the weight of the slab is large enough, the sole should be broad.

Because excavation for construction of the Foundation is a very time consuming job, mostly used excavator. Before excavation it is desirable to remove the useful layer of soil. Ditch digging 30 cm more than the approved size of the Foundation. Part of the ground will be useful for back filling, so no need to take out all the soil excavated from the pit from the site. The bottom of the pit and rams.

One of the most important issues in the construction of the house is basement waterproofing. This is especially important when the project includes a basement. In this case, external and internal basement waterproofing from ground water the task priority. There are four main types of waterproofing a block Foundation. It concrete blocks are most often used for foundations of houses and other auxiliary buildings and structures.

Monolithic basement walls poured on the technology of monolithic strip Foundation. In a nutshell: digging a trench, gets sand cushion, if necessary, set the formwork, waterproofing is placed, is the reinforcement, filled with concrete. If the first poured floor for basement, formwork for casting of walls is established only after complete drying of the concrete. Otherwise bracing of formwork under weight of fill of the mixture for the walls can be pressed into the floor of the basement and form pits.

If you need to reinforce the basement walls, we can handle the work independently, without resorting to expensive services. The main thing – to know the technology and features of the reinforcement, monolithic walls. By adding a simple reinforcement concrete becomes more durable and reliable concrete. This applies when the device bearing structures (such as walls of buildings).

Note that the carrying out of drainage works to drain the basement of the house will significantly reduce the area of the basement. First of all you need to pay attention to its height: it will inevitably decrease by 20-30 cm, as the drainage from the basement without laying drainage pipes and floor elevation will not work. The only way to preserve the aesthetic appeal of a well-ordered space.

Microclimate in any basement best supports the air handling system. It consists of two ducts, one for air intake and the other for exhaust. The lower end of the supply pipe is attached 50 cm from the floor of the basement, and the top needs to protrude beyond the level of the soil at 1 meter. The lower end of the exhaust pipe is located at 150 cm from the floor of the basement, beyond the top ridge of the roof 50 cm.

Basement insulation inside – it is a necessary measure, when exterior insulation is not possible or not profitable cost. Conduct internal basement insulation is possible only on a dry Foundation walls. However, there is a risk of increasing the rate of destruction of the Foundation due to its freezing. The area of freezing inside of the base will increase a lot, which in combination with high humidity, very quickly removes Foundation failure.

If the basement will be used as a room, for example, gym, playroom or office, this room is supported by a complete system of heating – is an offshoot of the General heating system of the house. Then the heating of the basement of a private home is one of the types of fuel: solid, gaseous or liquid. Also in this room is possible to install an independent boiler or electric heating. Read related articles on the subject of How to install replacement basement windows

Only well-equipped basement will be dry, without any smell of damp, and only use it as a full additional floor. It equipped with various storage rooms and a full room – boiler room, Laundry room, bath, wine cellar, Billiards room, etc.

Leave a Reply