Basement windows cost

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about Basement windows cost

In the basement repair the machines and keep them in garden tools, different technique. In the basement you can put a heat pump, ventilation equipment, water pump, Central vacuum and other equipment smart home. When building your own home, few who can avoid the temptation to do a basement conversion. Browse some photo of Basement windows cost

Before you start to build a cellar, it is necessary to check the suitability of the land, namely, how it is saturated with moisture and as close to the surface are ground water. To precisely to understand, the need to invite experts-Hydrogeologists. They will conduct appropriate research, take soil samples, analyze and give a detailed answer. But in most cases even with the naked look in order to make the right conclusion.

The order of construction of the basement depends on the level of groundwater. If they are too close to the surface, first formed the floor. Otherwise, work can begin with the construction of walls. First excavated pit with some margin in width (for the device of the formwork). Formed a cushion of sand and gravel. You then install the formwork, laying a waterproofing material, laid rebar and poured concrete.

If you decide to make a basement below ground, you should consider the depth of the groundwater and the soil type. If these characteristics allow you to drill into the ground, the Foundation to a house with a basement can be made in two versions: a monolithic concrete slab or strip Foundation. In the first case, it can be directly on the plot to fill the desired area with concrete or to use a ready-made factory plate. If selected, the construction of strip Foundation, it can also be done in different ways: modular and monolithic.

Digging trenches for the Foundation or basement is keeping all features of the project. Development of pits should include the necessity of removal of soil from the site and its disposal in landfills. Construction company Etalon, if needed, ensures the removal of soil during excavation works.

Waterproofing of underground (ground) floor of a private house, i.e. the basement (cellar, basement, underground) must be done at the construction stage. But, if the problem is already in the process of operation, it will have to perform internal waterproofing of walls, floor and even ceiling of the basement, i.e., from inside the premises.

The most reliable will be a monolithic wall. They still at the stage of creating the armature plate make the vertical reinforcement bars: outer – length 1.5-1.7 m, inner 1.2-1.3 m. When the base plate attains 70% of its strength, continue to knit the reinforcing frame in accordance with the project. Reinforced inner and the outer walls serve as ribs for slab Foundation. Height of basement walls may be different, depending on the destination premises.

Reinforcement of monolithic basement walls is performed using the power set, which is selected based on the thickness of the walls and anticipated load. For monolithic walls, often use a box scheme. In this case, the armature is collected by means of two power series and connecting horizontal rows of thin reinforcement products. Reinforcement of retaining walls perform better under the supervision of experts. For this work used special fittings with thickness up to 50 mm.

Water from the drainage system can be abstracted in a septic tank, a drainage ditch or specially for this purpose built cumulative well. In the simplest version it is a deep pit, filled with broken brick, gravel, crushed stone, fine construction debris. It is important that the bottom of the pit was permeable, so when it is digging, it is desirable to achieve a layer of soil, which would be a sufficient amount of sand or sandy loam.

If the basement has a small volume, it is possible to use a slightly simplified scheme. The main difference between supply and exhaust air duct is that it delivers and removes air with a single design, which has both exhaust and supply channel. However, in this case will be confined to only a small volume of air.

If you plan on the first floor the arrangement of heated floors, then be sure to provide sufficient thickness of insulation of the floors to minimize heat losses. The mounting and location of the heating pipes in some extent depends on the placement of the waterproofing layer. If the membrane is under a layer of insulation, the pipes can be fastened to the insulating plate with a flexible heating pipes, fasteners which do not damage high-strength insulation.

In any case, when you install any heating first, it is necessary to consult with certain services, responsible. Self-install in the basement, you can except the heater, in all other cases will need the assistance of experts and professionals. The calculations that will be associated with the heating system in the basement, also it is better to trust the professionals. Read related articles on the subject of Basement windows cost

Only well-equipped basement will be dry, without any smell of damp, and only use it as a full additional floor. It equipped with various storage rooms and a full room – boiler room, Laundry room, bath, wine cellar, Billiards room, etc.

Leave a Reply