Basement windows canada

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about Basement windows canada

It is considered that the construction of basement costing too much. But upon closer inspection, it turns out that all numbers in this case, the arguments are insufficiently thorough. Utility rooms are needed in any home. They will be made in the form of a basement or spread out in width, as this allows the site — it should be decided in each case individually. House with a basement always has more value. Browse some photo of Basement windows canada

Basements and high underground is built on dry soil. Often in rural homes, the floors arranged on the joists, which are placed on the brick pillars, and they rest directly on the ground. In this case, under the floor boards formed the underground, the height of which is typically 150-250 mm. If the height of the underground is over, it will increase heat loss if it is less, it will deteriorate underground ventilation.

Projects single-storey houses with a basement can be called the most common. The basement here is typically used to accommodate boilers, communication systems, etc. During the construction of the basement, special attention should be paid to the location of groundwater and the level of freezing of the soil, as these indicators influence the depth of the base under the house and the depth of the basement. If you do not consider these parameters when raising the groundwater in the basement moisture appears, which is going to be quite difficult.

The Foundation should be doing the most robust and reliable that its walls could successfully resist the horizontal shifts due to the pressure of the surrounding soil. As a Foundation base is recommended to use a pillow of in-situ concrete, associated with ribbon cage. As the weight of the slab is large enough, the sole should be broad.

Development of the Foundation pit. For this we need a backhoe and dump truck for the removal of excess soil. There are few secrets. But the soil it is necessary to take not completely but only 2/3. The remaining third is still useful to us. Digging a Foundation for a house with a basement is done based on the design size of the house, adding roughly one and a half meters at the edges, so that later you can safely seal the resulting structure.

One of the most important issues in the construction of the house is basement waterproofing. This is especially important when the project includes a basement. In this case, external and internal basement waterproofing from ground water the task priority. There are four main types of waterproofing a block Foundation. It concrete blocks are most often used for foundations of houses and other auxiliary buildings and structures.

Basement walls, as a rule, is combined with strip foundations, and the ceiling — with a ground floor. The thickness of the walls at their depth more than 1 m is determined from the lateral pressure of soil. Dry soils have the basement walls post concrete and reinforced concrete. To increase the strength of the walls, built of bricks and concrete blocks, in horizontal seams of a laying, 30-40 cm in height, put the reinforcement mesh and top and bottom walls along their perimeter, arrange reinforced belt. In addition to stability, the basement walls should have good heat-quality and reliable waterproofing.

There are different patterns of reinforcement of the basement. For walls made monolithic method, most often used box diagram. The Assembly of the valves is performed by the device of two power series and connecting them with horizontal, thin reinforcing elements. For a basement wall reinforcement mesh is chosen sufficiently elastic, and the binding of elements it is better to use wire without welding.

If you wish to make a more efficient and fast drainage system, it is possible to provide for the installation of the special pump. The drainage unit is able to pump out all the water from the basement. But it is worth remembering that these pumps cost money and require manual control (turn on and off it by yourself). Therefore, it is better and cheaper to make gravity flow drainage system.

If in the basement will create a workshop, you should take into account that the ventilation should ensure effective removal from the premises of the exhaust gas, vapour of combustive-lubricating materials, which pose a serious risk to health. There are many cases where people just choked in the Studio from the exhaust.

When building a house on wet soil, depending on the values of the estimated load insulation of a floor heated room in the basement or cellar should be carried out according to the scheme adopted for load-bearing floors on the first floors of buildings. Created when groundwater pressure and, depending on the loads that create columns and walls, the insulation material of extruded polystyrene foam can be placed under concrete slabs laid on gravel, and over them.

In any case, when you install any heating first, it is necessary to consult with certain services, responsible. Self-install in the basement, you can except the heater, in all other cases will need the assistance of experts and professionals. The calculations that will be associated with the heating system in the basement, also it is better to trust the professionals. Read related articles on the subject of Basement windows canada

If you decide to build it all yourself, then be sure to get support. Even the trite advice of neighbors who have already made the cellars in their houses and know all about the level of groundwater and the terrain. When possible, the construction of the basement must be done, by hiring professionals.

Leave a Reply