Basement vent windows

The basement of a country house – one of his major premises. In a country house it can be used for technical needs – the garage, boiler room, water meter unit, Laundry facilities. Or for leisure, placing in a swimming pool, billiard room, sauna, gym, wine cellar, workshop and other auxiliary premises (storage rooms, etc.), which you would not like to see in the first or higher floors of a cottage or a bath. See below to learn more about Basement vent windows

The basement as technical facilities allows to host the area necessary engineering structures to house, for example, the heating system (boiler), water heaters, filters and more. This will allow you to free up space in the rooms (for example, to get rid of the boiler in the kitchen). Browse some photo of Basement vent windows

Before the construction of basements it is necessary to conduct all the necessary calculations and make drawings of the future building. This should take into account the depth of soil freezing, as well as the negative destructive influence of groundwater. Groundwater is able to make the basement unsuitable for use. Prolonged exposure to groundwater leads to the destruction of the Foundation, and then the entire structure.

Depending on the capabilities of the host building and the technical capabilities of the structure, the basement can be expanded, both in depth and in width. In any case, the basement is a special value. To begin construction, you must develop basement project. When selecting a location for building future home, if possible, keep in mind that if You decide to expand into the basement, it’s easy to face a problem of groundwater. In the case where the selected location for construction of a residential house or an industrial building, has a rocky terrain and the groundwater level increases (permanent or seasonal), the cost of equipment the basement is greatly increased.

When choosing a Foundation you need to consider several factors: type of soil, the total area of the future construction, the materials used, the ability of the excavation, the presence of a cellar under the extension. As the basis can be chosen tape or pier Foundation.

Because excavation for construction of the Foundation is a very time consuming job, mostly used excavator. Before excavation it is desirable to remove the useful layer of soil. Ditch digging 30 cm more than the approved size of the Foundation. Part of the ground will be useful for back filling, so no need to take out all the soil excavated from the pit from the site. The bottom of the pit and rams.

Protection of the basement from the water – one of the main tasks in its construction. It includes a range of measures to ensure the water tightness of basement walls and floor as well as the prevention of rise of water inside the structure through the capillaries. Most reliable waterproofing can be done only at the stage of construction.

During the construction of monolithic basement walls are equipped by technology of strip Foundation. To dig trenches on the bottom is filled with sand, installed formwork. After carrying out waterproofing measures laid reinforcing mesh and poured concrete. If you decided to pour the floor, then shuttering for shaping walls installed only after final solidification of the concrete. Otherwise, formwork bracing under the weight of the solution can be pressed into the floor, thereby forming unnecessary holes.

Perimeter walls the best way to do solid, and the reinforcement of basement walls will be the key to his long life. Don’t forget that fittings must be laid before pouring the basement floor. I should add that the reinforcement must be done, regardless of the thickness of the future walls. As reinforcement best suited to the 12 mm rods, the first row which must be mounted in 5-7 cm from the soil surface. The greatest strength of the wall will give a double reinforcing mesh. The size of each cell should not exceed 40×40 cm.

The drainage under the house consists of a system of pipes (drains), manholes and pumps. Drainage pipe are based, they collect excess moisture through holes or joints and lead her to the gathering place – wells. If breathing is difficult, the natural outflow of the applied submersible pumps, which are placed on the bottom of the wells – they forcibly take the water out of the house. A mandatory principle in the drainage device is a bias towards wells.

In fact, ventilation is a system of pipes or shafts to ensure the normal parameters of humidity, temperature and ventilation in the house. The ventilation of the basement of a private house may be compulsory and consist of a network of ventilation ducts with the supply device and an exhaust fan, and can be natural and consist of a supply and exhaust pipe.

Waterproofing membrane under the concrete Foundation can be placed over the foam and underneath. In both solutions, insulation and waterproofing basements or cellars will have the same performance. The traditional laying of the membrane on the concrete base insulation layer will protect it during construction works from mechanical damage and provide a robust enough surface for laying the slab Foundation.

The procedure for heating floor has its own quirks and nuances. Before the arrangement of heating it is recommended to take the necessary measures, which will not allow the heat to go out through the wall. This is done the insulation and waterproofing of exterior of the walls. To accomplish these goals, we need to dig out the Foundation. Read related articles on the subject of Basement vent windows

It is worth noting that to do basements in existing buildings is not recommended because it will cause high construction costs. In addition, increase the risk of damage to the Foundation of the building, especially if the device runs basements with their hands.

Leave a Reply